Thingiverse

The filament on the Anycubic Mega S tends to get under quite some tension between the filament sensor and the extruder, especially when the printhead goes higher up. You can adjust the filament sensor to some sweet spot for a certain height, but at other heights it will not run smoothly.

This is a remix of the base of both, the initial case w/o cooler (https://www.thingiverse.com/thing:2032226) and a variant with a cooler opening (https://www.thingiverse.com/thing:2480191). This base is the same for both, and I added a tiny stand extension where you can slide in an SSD. Please get the top cover as needed from either of the two remix sources.

The new Bosch SmartSystem allows devices to communicate via a serial bus connection. While a bike initially comes with a the remote control device and a Kiox300 display in the first place, you can actually chain more than two devices.
I designed some different bases for the adapter that you can easily mount on the handlebar or the stem. They are much smaller than using a second one of the large original Bosch adapters.

There are by now tons of Continuity Camera holders for the iPhone, but for some reason none of them fitted well for my iPhone 12 (with bumper) on my Macbook Pro.So I made one exactly for this combination (and probably all iPhone 11 – 14, if they are no thicker than 10.3mm incl. case). Fits like a glove!You can mount the phone horizontally and vertically (lifts the camera a bit more up). There is also a small nut at the bottom to prevent the volume buttons to be pressed when inserting the phone horizontally.