The filament on the Anycubic Mega S tends to get under quite some tension between the filament sensor and the extruder, especially when the printhead goes higher up. You can adjust the filament sensor to some sweet spot for a certain height, but at other heights it will not run smoothly.
So I decide…

This is a very handy clip to easily fasten a tarpaulin and span it with a rope. For strength and outdoor usage, PETG or even ABS printing is advised. Use sufficient infill also (min 25%).
You need an M6x16 Screw & Nut (M6x20 will do also). The screw goes into the clip, the nut into the wing grip.

This is a remix of the base of both, the initial case w/o cooler (https://www.thingiverse.com/thing:2032226) and a variant with a cooler opening (https://www.thingiverse.com/thing:2480191). This base is the same for both, and I added a tiny stand extension where you can slide in an SSD. Please get t…